Maxsa Innovations 40218 – What I Like And What I Do Not Like About It

Recently, I bought the Maxsa Innovations 40218 Motion-Activated Dual Head LED Security Spotlight from Amazon.com and I though I’ll do a quick write up about it.

The 40218 works right for a small-to-medium area that needs to be lit up. The installation is very easy and simple to set up. The settings can also be adjusted without any problems whatsoever. So far so good.

The only issue is that the lights go on during the day time. Yes my LED light is on in broad day light! None of my other solar lights seem to have this problem.

Oh yes, I am moving in front of the light, but this should not be so. I wish Maxsa Innovations would do further adjustment on the sensitivity of the sensor during day time. I have not been successful in changing the settings, nevertheless, I will try again.

My opinion is that it is a good light, bright enough, and it works well. But, if you are willing to spend $20 or $30 more, you can probably get a better light with a better fixture after all. But would you spend the extra money just to light up your porch?

Anyway allow me to share with you why I love this light. Firstly, the range of the light is quite wide. There are three controls that can be set. You can set the time when you want the light on, night or day.

You can also specify the time span it should stay on once it senses motion to last anywhere between two to four minutes. It is programmed to stay on through all motion and normally the timer is set when the motion stops. Actually, 45 seconds to 5 minutes is pretty accurate.

The sensitivity of the Maxsa Innovations 40218 can be changed between high and low. I wanted the light to pick up movements of cars and people. I therefore set the sensitivity to medium. It helps my daughter follow a lighted path along the garden from the driveway to the porch. The skunks and rabbits have still not ventured out, they’re in the dark!

The light is pretty durable and strong. I actually dropped it from about 10 feet during installation. It did not break even then and it still works!

The light glows brightly in pitch darkness; it does not blind you, it is subdued; and it does not attract the bugs. There’s no way a solar powered light will march an electric powered light anyway.

You can differentially point the two lights to wherever you want. This makes it perfect to light up driveways and walkways, or two corners of your house.

The angle of the solar panel is adjustable. The panel can be put in the best angle without compromising on the position of the solar light. The cord between the two is long enough.

The light has a sensory range of approximately 25 feet. Sounds like a long range. But when put up on the 15-foot garage peek, it has only a 10-foot motion sensory range. The 180 degree range to pick up motion is useful only if you place it on the ground.

You can point it to positions that you need it to pick up motion from. If not on the ground, you have to get pretty close before it lights your way. On the whole, it is a great product. And I plan get a few more of them, now that I know where to put them up to get the best light coverage.

If you are looking for a LED solar powered motion sensor security light for your home, click on the button on the right and get the Maxsa Innovations 40218 from Amazon.com and have it delivered to your doorstep right now.

Saving Energy By Checking on Your Home’s Insulation




Most people don’t think of it, but it’s really a good idea to keep an eye on your home insulation. If you find that it is damaged or it is simply not doing its job, you may have to replace it.

This can be very expensive; however, as long as you have faulty insulation, you are wasting money on heating and cooling you home. Here’s what to look for when you check your insulation:

An empty spot is called a void. You will usually find these near light fixtures after electrical work has been done. The workers will usually push the insulation out of the way. You can fix this easily by putting in more insulation or filling it in with a spray-in foam insulation.

Check your basement ceiling. If it’s not insulated, you can lose a lot of heating and cooling into your basement. It’s pretty easy to insulate your basement ceiling, and there are lots of companies that can do it for you if you don’t feel up to doing it yourself.

Your attic is another area that can waste a lot of energy if you don’t insulate it. Again, you might want to do it yourself, since it is pretty simple, or you could hire a company to do it for you.

When you are checking your attic, be sure to check the ventilation system. If the ventilation system is clogged up, your attic will retain a lot of heat in the summertime, and that will heat up your house.

Be sure to keep these vents clean so your attic can air. If you don’t have any vents, look into installing them. Whether you do it yourself or hire a company to do it for you, your basement and attic can be insulated with roll insulation or with spray powdered insulation. If you decide to do it yourself, be sure to wear a safety mask to keep particles out of your lungs.

Be sure to check all your hot water pipes. There are many affordable ways to insulate your hot water pipes. One of the easiest and best ways is to get a length of foam cylinder. They usually come in four-foot lengths. Just cut it to the length you need and split it down the side. Then you can just fit it over the pipe and secure it in place with duct tape.

You can also insulate your hot water pipes with fiberglass insulation tape, but this is kind of tedious because you have to unroll it all the way down the length of the pipe. If the pipe is under your house or in a tight spot, this can be really hard.

Check your walls! If you have already checked your basement and your attic and found that the insulation isn’t good, it’s a pretty good bet you have the same stuff in your walls. Sometimes the best thing to do is to have new siding put on the outside of your house.

Of course, you can also do this yourself if you are handy. Siding is a good choice because it insulates nicely, looks really good, and increases your property value.

Be sure your windows are energy efficient. A single pane window will not insulate your home. If you can change out your old windows and replace them with new, double-paned windows, it will really make a difference.

However, if you can’t afford that, you can use good, heavy insulating curtains inside your home to help seal out the heat and cold. You will be surprised how effective this is and how affordable.

If you can’t afford to add insulating curtains to your whole house all at once, this is a project you can easily do room by room. Start with areas where people spend the most time, such as the family room and living room, and then move on to bedrooms, dens, and so on. Of course, you could also use this plan to change out your windows one-by-one.

For heating and air-conditioning equipment, as well as ventilation equipment, be sure you always have clean filters installed. This will cut down on your heating and cooling costs since all of this type of equipment must work harder to pull air through a dirty filter.

Even though filters can be a little pricey, it will pay off in heating and cooling costs to keep clean filters in all your equipment. Washable filters should be cleaned weekly. Filters that can only be replaced should be replaced monthly.

Concept SL-100 LED Solar Security Light Review – Should You Get It?




If you are a home owner, what do you thinking is your biggest concern? I would say keeping your family members and your household items safe. Therefore, it is understandable you will spend lots of money to install modern security gadgets just to make your home safer.

Nowadays unemployment is the largest crisis that we are facing so that it is a known fact that there is a large increase in the incidents of looting, theft, burglary and murder. Just look at what happened during the month on August 2011 in London.

One of the main reasons of theft in a neighborhood is dim lightning arrangements at almost every house at night. Think about it, the thieves feel safer in dark areas since no one can see what they are up to.

Hence, in order to make the thieves uncomfortable, there is a need to provide sufficient lights in some dark areas around your house at night. That is where the Concept SL-100 LED Solar Security Light comes in handy.

Concept SL-100 LED Solar Security Light – My Personal Experience

Firstly, the Concept SL-100 works using solar cells which are charged during day time using solar energy, and it is capable of providing sufficient light at night time. SL-100 32 LED solar security light is a simple gadget which will deter thieves to make an attempt to break into your home as they feel uncomfortable around bright lights.

The Concept SL-100 has a motion sensor built in which projects an infra red beam which is not able to be seen by the human eyes. When a person comes nearer to the light and crosses the IR rays projected by the SL-100, the circuit gets opened and the LED fitted on top of your house will be activated. This will make thieves uncomfortable and he’ll think twice about breaking into your home.

The Concept SL-100 has a very compact and attractive design. It comes with bright LED lights which can be used in areas such as driveway, patio, garden, entry point, and even around trees in your backyard.

As the SL-100 is built using materials which can withstand harsh environment such as rain, snow, wind and even high temperatures, the product will last for a long time. Since there are no electrical wires to mess with, the solar security LED light can be easily installed.

Is it worth your investment? Well, it is a small price to pay to keep your family members safe at night. Click on the button on the right and head over to Amazon.com to get a unit of Concept SL-100 delivered to your home right now.